So it's not surprising that people often ask me for advice about putting together a backyard storage building. Sometimes I get asked questions that I couldn't possibly answer: "Do you think my husband and brother-in-law can build me a garden shed?" Or, "Would an 8 x 10-ft. shed be big enough to store all my stuff?" Gee, ma'am, I couldn't say. But often, the questions have something to do with shed design, framing or siding options. There, I can help. And so with these inquisitive souls in mind I present my favorite tricks of the shed trade.
Start by setting deck blocks on the ground, positioned as shown in the plans. While the area doesn’t have to be perfectly level, you should make the ground roughly level where each block will rest. Temporarily place some straight 2-by-6 lumber on edge in the top grooves of the blocks to orient the blocks in a straight line. Arrange two rows of four blocks parallel to each other to form both long walls, then measure diagonally across the outside corners to determine how square the arrangement is. If the two long walls are parallel, and diagonal measurements taken across corners are equal, then each corner is guaranteed to be 90 degrees. Finish up by placing one deck block in the middle of each 6-foot wall after you have aligned and squared the 8-foot walls.

P.S. Hurricane/Tropical Storm Irma hit my area and knocked out power, downed a few trees, blocked my neighborhood’s entrance, etc. but the UDH was thankfully fine. I just have a few extra downed limbs to chop up for the new fire pit. I hope those of you impacted are, above all, safe — including your pets. And I’ll be saying a prayer for those who weren’t as lucky. Thanks for those of you who have sent comments my way via social media. 💜
Since it’s made out of plastic, there’s nothing glamorous about this shed’s appearance. Also, if you plan on storing expensive stuff in this shed, you should perhaps think about other options, because this one is a low security shed. Although you can install a hard to break lock, the thief can still cut through the plastic with ease, thus rendering your lock useless.
This open concept garden shed almost looks like a farmhouse. The open area would be perfect as a gathering area for guests or partygoers for your next backyard soiree. The super cute furnishings make this space absolute charming and it would be hard to pass up the opportunity to sit in this adorable, tiny space. This is a great space to utilize storage and double as an entertainment venue for later.
Door placement is also important. You often see doors placed on the gable end of the building, which looks nice, but makes it virtually impossible to reach items stored at the rear of the shed. A better alternative is to put the door on the long side wall, so that you'll be able to access items to the right, left and back. Another option is to install doors on both gable-end walls, so that you'll be able to easily reach items from either end of the shed.

This year’s pub shed is one of the most versatile we’ve ever built. The bar and covered patio area make it a perfect place to entertain or just hang out. The steep roof and sturdy lofts provide tons of extra storage space. And the high-tech materials, including reflective roof sheathing and prefinished floor panels, add to the shed’s comfort and convenience. Of course, if you don’t want a bar, you can install a bank of windows in its place. In fact, without too much more work, you could eliminate the front porch and build one big shed for even more storage space
This fantastic outdoor space has been termed the “She-Shed” due to its high function and feeling of being a getaway. You do not need to make space a specific space for women, but in this case, the shed is meant to resemble a sort of “man cave” for the opposite sex. When it comes down to it, you can decorate a shed in any way you feel comfortable and even turn it into a working studio or office space.
This worked awesome. Build a 8x12ft greenhouse using these brackets. Be careful, the brackets are as sharp as a razor and will cut very easily, but it worked really well. Buy two, and 12ft 2x4s and 8fter's work great. Buy a deadblow hammer cause it takes a little persuasion since wood is never perfectly straight, but once you get the gist of it, you're on your way.
For me, heating with firewood is more about feeling self-sufficient than it is about lowering my utility bills. I also like cutting and splitting logs. It's good exercise and the source of my wife's wry nickname for me, the Saturday Lumberjack. But storing and keeping the wood dry is a hassle. Tarps can trap moisture, promote rot, and be difficult to remove after a snowfall. And stacking the wood inside is a poor choice, unless you enjoy the company of insects and mice.
Flowers are always a good idea when it comes to creating a tiny shed space. No matter what you are turning your shed into, you should be sure to decorate the landscape around it appropriately. Going for a rustic, desert theme? Succulents and cacti are your go-to. Prefer an English garden space? Gorgeous multi-colored flowers and tiny table set up for tea would be perfect.

First and foremost, you will want to construct an ornate case to serve as your liquor cabinet. This should be easily accessible to whomever may be fulfilling the function of makeshift bartender. Secondly, a handcrafted station should be installed in a fashion that is inviting to all guests. L-shaped formats can help you cram in tons of extra company, but horizontal rows are equally alluring. When it comes to the counter tops, any composition will do. Just make sure the surface matches the stools.

Next, frame the floor with 2x6s. Start by cutting the 12-ft.-long rim joists for the front and back and marking the joist locations. Cut the joists and nail them to the rim joists. When you’re done, square the joists (Photo above). Then use a taut string line or sight down the 12-ft. rim joist to make sure it’s straight. Then drive toenails through the joists into the 6x6s to hold the joists in place.
It's a work in progress and likely a labor of love for Rob, aka Weekend Shed Head, who chronicles the construction of his backyard man cave in Nottingham, England, on his Instagram account and YouTube channel. An experienced and enthusiastic do-it-yourselfer, he sort of makes things up as he goes along and seems to know what he's doing. Along the way, Rob posts photos of train stations, the curry dinners and full English breakfasts he cooks, and charming flowers and decor in the garden.

Phase # one: Talked about previously mentioned earlier determine where you can spot your get rid of inside an optimum area, allow enough distance from hedges or partitions for straightforward access to the sides. Use pegs and twine to attract out your foundation 2 inches (5 centimetres) larger than the location from the developing on either side. Finally, a figure out angled to guarantee the spot is square.
These LED rail lights are the perfect, cost-effective way to light up an outdoor space without lightening the wallet. Whether you need a ton of lights for your next garden shed bar party or just a few to light up your child’s playhouse, these lights are great because all they need to use to work is the actual sunlight. No need to worry about batteries or extension cords when it becomes known! They do all the work for you.
The next step is to install the 1-in. x 9-1/4-in. trim board that fits against the soffit and runs around the perimeter of the shed and porch. This wide trim board forms one side of the false beam that runs around the porch ceiling. Add a 2×4 frame to the underside of the porch ceiling to create the false beam. Then nail the grooved panels to the porch ceiling and cover the 2×4 false beam with trim (Photo above). You can install the corner boards at this stage, but the battens will have to wait until after you’ve built and installed the windows. Figures S – V show details for the siding and trim installation.
After crosscutting the steel roof panels, we fastened them to the skip sheathing using self-tapping screws with a rubber gasket under the head. We drove the screws with an 18-volt drill and a socket wrench attachment, but we'd advise using a more sturdy nut driver because penetrating the roofing requires a fair amount of force. Finally, we screwed the diagonal braces to the posts.
Studio Shed’s design philosophy does not stop at good looks. Our Signature Series and Summit Series models are designed with efficiency and performance in mind. Unlike traditional backyard sheds, we use the highest quality materials available to create spaces that perform to residential standards and meet the most stringent building codes throughout the country. A Studio Shed is an extension of your home, thoughtfully designed to maximize space, functionality, and comfort.
The roof panels are heavy and a bit awkward, so round up three strong helpers for this part of the job. Move the panels into position and lean them against the front and back walls. Then set up ladders inside the building for two helpers and push one of the panels up to them. Slide the panel up the roof until the bird’s-mouths drop over the top plate of the wall.
×